Is Thicker Oil Better For High Mileage Cars?

Will using thicker oil stop burning?

A lot of oil-burning takes place because an engine’s piston rings are worn out, and thicker oil won’t fix that.

Using thicker oil is also a particularly bad solution for modern cars.

They use low-viscosity oils that splash easily all over the moving parts of the engine to make sure they’re all lubricated..

Which oil is thicker 10w40 or 20w50?

The smaller number, (the 20 part of 20w-50) describes how the oil behaves at 40 deg C and a 20w at 40 deg C is about 10 times thicker than your engine wants. A 10w-40 is better at around 6 times thicker and a 0w-40 is much better at about 4 times thicker.

Will it help to run thicker oil in a car with over 100 000 miles?

For an older, high-mileage passenger car, it is recommended to switch to a thicker viscosity oil, such as 10W-30, when approaching and passing 100,000 miles, to lubricate the engine well for preservation.

Is 5w30 good for high mileage?

Both high mileage 5w30 and 10w30 engine oils have the same additives, the only difference is the viscosity at cold startups. Since both oils have the same operating temperature viscosity (30) and additives, they will perform exactly the same. However, 5w30 flows much better than 10w30 during cold starts.

Is 20w50 oil thicker than 10w30?

SAE 20W50 is thicker than 10W30, so it’ll be longer to reach your engine parts during cold start, but the 20W50 could give your engine extra protectiom when it’s heat and being used for long time running. The sound would be smoother than the 10W30 even you get less responsive on the acceleration.

When should you use 20w50 oil?

20W50 motor oil is suitable for warmer climates, where the higher temperature causes the oil to thin. It is also useful for vehicles subject to hot temperatures and for those used for high-stress activities such as hauling or pulling trailers.

How do you fix high oil consumption?

While excessive oil consumption can be a costly and timely fix , sometimes there is an easier fix, such as the PCV valve or oil pan gasket. In the case of internal engine parts, like piston rings, unless you’re an experienced DIYer, it may be best to leave this option to the mechanic.

Is it OK to use 15w40 instead of 5w30?

5w30 flows better than 15w40. 5w30 provides best cold start properties. Using 15w40 instead of 5w30 will increase your fuel consumption because of more load on your engine’s crank. No it won’t blow off,you will just wear your engine out quicker because the oil won’t flow to the moving parts as quickly !

What is the best oil to use in a high mileage car?

#1 – Mobile 1 High Mileage Synthetic Oil Mobile 1 High Mileage is a synthetic motor oil which is formulated to keep high mileage engines alive for as long as possible. The oil is more resistant to higher temperatures and has a less chance of causing leakage.

Which oil is thicker 5w30 or 10w40?

A 10w-40 motor oil is a thicker oil at startup than a 5w-30 motor oil. Therefore, 10w-40 oil clings to the engine’s moving parts more than the lower viscosity 5w-30 oil.

What happens if I put 10w40 instead of 5w30?

If you use 10-w-40 instead of 5-w-30 specified by the manufacturer then the viscosity of 10-w-40 used by you will be higher and oil thicker than what is specified during winters. Similarly the oil viscosity will be higher and oil thicker than specified during summers.

Will thicker oil stop lifter noise?

If the oil is too thick then it will not pass through the tiny holes resulting in an increase in friction. The increased will not only lead to noisy lifters, but it may also increase the temperature a little bit. On the contrary, if the oil is too thin, it won’t provide proper lubrication as well as padding.

Should you use thicker oil in an older engine?

A: Yes. This is a practical method to improve oil pressure in an older, high-mileage engine. The slightly thicker oil film from the heavier base weight oil — 10W — can help protect worn engine bearings as well.

When should I use thicker engine oil?

Within reason, thicker oil maintains a better lubricant film between moving parts. Some have even used thicker oil in a leaky engine to prevent oil from seeping out. But really, thicker oil is not good for your engine. Not when “thicker” means higher viscosity than the manufacturer recommends.

Is it OK to use 0w20 instead of 5w30?

0w-20 is simply a different viscosity of oil. It won’t be an advantage to your engine if your manufacturer suggests you use 5w-30 and may indeed be a detriment to your engine. 0w-20 may be a recommended oil for certain conditions for your engine and may not be recommended for your engine.

Will thicker oil damage my engine?

Not only that, but the engine will waste energy pumping the thicker motor oil, reducing fuel economy. Since thicker oils don’t transfer heat as well as thinner oils, operating temperatures will increase, too, possibly leading to accelerated chemical break down and harmful sludge and deposits.

Can I go from 5w30 to 10w40?

As posted above, mixing 5w30 with 10w40 will give you an oil that performs somewhat better in the cold than 10w40, but less good cold than 5w30, and that has a viscosity a bit higher than 5w30 but a bit lower than 10w40.

Can you put 10w40 in a 5w30 engine?

The recommended oil viscosity for your vehicle, according to Kia documentation, is 10W-40. If you drive the vehicle in exceptionally cold weather, well below 32 degrees, you can use 5W-30 oil but even 10W-40 is still perfectly OK to use if outdoor temperatures are below freezing.