Quick Answer: How Do I Know If My Lawn Mower Coil Is Bad?

Can AutoZone test an ignition coil?

While you’re under the hood, you may want to test the spark plugs as well.

Ignition coils can fail due to the heat and vibration of the engine, but the most common problem is faulty spark plugs.

It’s easy enough to test your vehicle’s ignition coils yourself with a few tools from your local AutoZone..

What is the resistance of an ignition coil?

The ohmic resistance of the coil is around 0.2–3.0 Ω on the primary side and around 5–20 kΩ on the secondary side. The winding ratio of primary to secondary winding is 1:100. The technical structure may vary depending on the ignition coil’s area of application.

How do you fix an ignition coil on a lawn mower?

InstructionsDisconnect the spark plug wire. Disconnect the spark plug wire from the spark plug. … Remove the blower housing. Release the starter rope from the mower handle. … Remove the ignition coil. … Install the new ignition coil. … Reinstall the blower housing. … Reconnect the spark plug wire.

How do I check a ignition coil?

Connect your multimeter to the positive terminal or pin of your coil, and to the high output terminal that goes to the spark plug. Most ignition coils should have a secondary resistance falling somewhere between 6,000 to 10,000 ohms;however, refer to manufacturer specifications for the correct range.

What causes no spark on lawn mower?

If no spark appears, check for broken wires, shorts, grounds or a defective stop switch. Once you have confirmed that the stop switch is working, reconnect the spark plug lead.

What causes a lawn mower coil to go bad?

The leading cause of premature failure of an ignition coil is due to a worn or bad spark plug ignition cable. A bad spark plug ignition cable will have a much higher than normal resistance. This high resistance causes a very high amount of voltage to be generated from your ignition coil’s secondary winding.

How do you test an old ignition coil?

Connect your multimeter to the positive terminal or pin of your coil, and to the high output terminal that goes to the spark plug. Most ignition coils should have a secondary resistance falling somewhere between 6,000 to 10,000 ohms; however, refer to manufacturer specifications for the correct range.

What does a bad ignition coil sound like?

If you try to start your engine up and you hear a spluttering sound repeatedly, then you are likely experiencing an engine misfire that can be attributed to a bad ignition coil. You may still be able to drive your vehicle, but you will hear a lot of strange noises and even feel jerkiness as you accelerate the vehicle.

How do I know if my lawnmower coil is bad?

Replace the original wire with the in-line spark tester, and attempt to start the motor. Watch for the same intensity of a spark that you saw when the mower was cold, If there is little or no spark, the ignition coil is bad and needs replacement.

How do you check a lawn mower coil with a multimeter?

If you have a multimeter, turn its dial to the 20 K ohm scale, and insert its red lead in the common jack and its black lead in the jack marked with the ohm symbol. Test the meter before checking continuity by touching the leads together and verifying that you get a reading close to 0.

What would cause an ignition coil not to fire?

There are a few reasons for no spark, new coil pack could be defective, crank sensor, ignition module or bad wire in primary circuit, faulty ECM/PCM. You may have to have a good technician have a look, diagnose and estimate repair. … Wires were all hot but no spark.