Quick Answer: How Do You Get A Clean Distortion Sound?

Why does my amp sound distorted?

The higher the setting, the more intense the sound.

If you set the input gain very high on an overdrive pedal and increase the preamp gain, combined with a high level of guitar volume, you will achieve both pedal and amp distortion..

Is tube screamer overdrive or distortion?

The Ibanez Tube Screamer (TS9/TS808) is a guitar overdrive pedal, made by Ibanez. The pedal has a characteristic mid-boosted tone popular with blues, rock and metal players.

Should I get overdrive or distortion?

Overdrives are relatively low-gain, and rely on a tube amp saturating to get any really high gain sounds. As a result, if you’re after high gain without a tube amp, then distortion is a good bet.

What does overdriven guitar mean?

Overdrive refers to the sound made by a tube amp that’s pushed to its operating limit. Indeed, the purest overdrive sound comes from a maxed out tube amp, but since many players don’t want to blast their audience with too much volume, they use stompbox effects pedals to create overdrive.

Do I need both overdrive and distortion?

You only need more pedals if you want more pedals. Realistically, you can cover whatever ground you need with a RAT. If you want more of an overdrive and less of a distortion sound, then just turn the gain down a bit and turn the level up to push the front end of your amp a bit harder.

Is gain the same as distortion?

High gain just means you can get a lot of distortion from them. exactly, to elaborate: gain, distortion, overdrive, drive, ect, are all interchangeable terms to describe the same thing. like dave was saying, turning the gain up is increasing the strength of the signal in the pre-amp section of your amp.

How do you get distortion?

Turn knobs marked “gain” or “overdrive” all the way up. Turn other volume knobs down to get the loudness you want. Once you’ve proved you can get heavy distortion, dial things back to find the tone you want. Some amps won’t distort at low volumes.

What’s the difference between fuzz and distortion?

Distortion adds a consistent crunch or grit to what you’re playing. Whereas an overdrive takes your original tone and pushes it harder, a distortion pedal changes the sound completely and saturates the signal. … Fuzz alters the waveform into a square wave and can almost makes your amp sound like it’s broken.

Can a bad amp cause distortion?

1 – overdriving the amp, if you have the gains up too high, your asking the amp to produce more power than it can cleanly, so it is going to distort. 2 – too much power for your speakers. If the speakers bottom out or make loud smaking sounds, you may be overpowering them.

How do you change from distortion to clean?

If your guitar has a seperate volume knob for each pickup, you can roll down the volume on the neck pickup until it gives you a clean sound and just switch to the bridge pickup when you want distortion.

What’s the best distortion pedal?

The best distortion pedals you can buy right nowFender Pugilist Distortion Pedal. … Wampler Sovereign Distortion. … MXR M75 Super Badass ’75 Distortion. … JHS Modded ProCo RAT ‘Pack Rat’ … Boss DS-1 Distortion Pedal. … EarthQuaker Devices Acapulco Gold V2. … KHDK Dark Blood Distortion Pedal. … TC Electronic Eyemaster Metal Distortion.More items…•

Is the fulltone OCD a distortion pedal?

Every so often its creator, Mike Fuller, introduces a newer version, and despite all the tweaking, many guitarists still consider the OCD one of the finest overdrive/distortion stompboxes. And for good reason; it’s one of the few drive pedals that nails the sound and response of an overdriven tube amp convincingly.

How does Metallica switch from clean to distortion?

He totally uses the volume controls on his Les Pauls to create his distortion through having his Marshall’s run at high gain.

Can you use overdrive and distortion together?

The term “stacking” refers to connecting more than one overdrive, distortion, or fuzz pedal together and using them both at the same time. In order to get these “stacked” pedals to sound and work properly you’ll need to use them a little differently than you would if they were ran alone.

Where should I put my fuzz pedal?

So, if an OD is on after the fuzz – you’ll boost the OD with the fuzz and the OD’s EQ/clipping/compression will do most of the lifting. I usually keep my fuzz pedals as high up the chain as possible, usually to keep any buffers from hitting them and also cause I like to boost my OD’s with a fuzz from time to time.